Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   - 7.2. Coupling
      7.2.1. Main cylinder of coupling
      7.2.2. Working cylinder of coupling
      7.2.3. Coupling details
      7.2.4. Vyzhimna bearing
      7.2.5. The directing bearing
      7.2.6. Coupling hydraulic actuator
      7.2.7. Coupling pedal
      7.2.8. The blocking coupling switch
   + 7.3. Cardan shaft and cardan hinges
   7.4. Back and forward axes
   7.5. Bearing, epiploon and half shaft of the back bridge
   7.6. Epiploon of a reducer of the back bridge and forward axis
   7.7. Zadny Bridge
   7.8. Forward half shafts
   7.9. Replacement of covers and dismantling of the CV JOINT
   + 7.10. Electromagnetic drive of a forward leading axis (ADD system)
   7.11. Forward reducer
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes





7.2.4. Vyzhimna bearing

Removal, check and installation

PERFORMANCE ORDER
1. Remove the working cylinder.
2. Remove transmission.
3. Get a spring bracket from a spherical support of a fork.
4. Remember as fastening of the vyzhimny bearing to a fork looks, remove the bearing (a photo at the left). Remove a fork (a photo on the right).
5. Check a condition of a dust cover and a spring bracket. At detection of signs of wear replace these details.
6. The bearing has to rotate freely, otherwise replace the bearing.
Prevention

It is forbidden to wash out the bearing in solvent.
7. Before assembly grease with refractory greasing of dredging under a spherical support of a fork, under a pusher of the working cylinder and a place of fastening of the bearing.
8. Establish a spring bracket (a photo at the left) and grease with refractory greasing the bearing plug (a photo on the right).
9. Install the bearing on a fork.
10. Dress the bearing on a check point shaft. Pass a fork through a cover, grease a support and dress a fork on a support, having pressured her before click (a photo at the left). Check freedom of movement of the bearing on check point shaft vents (to a photo on the right).
11. Slightly grease with refractory greasing a persistent surface of the bearing.
12. Further assembly is carried out upside-down.