Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   + 7.2. Coupling
   + 7.3. Cardan shaft and cardan hinges
   7.4. Back and forward axes
   7.5. Bearing, epiploon and half shaft of the back bridge
   7.6. Epiploon of a reducer of the back bridge and forward axis
   7.7. Zadny Bridge
   7.8. Forward half shafts
   7.9. Replacement of covers and dismantling of the CV JOINT
   + 7.10. Electromagnetic drive of a forward leading axis (ADD system)
   7.11. Forward reducer
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

7.5. Bearing, epiploon and half shaft of the back bridge

Removal and installation

PERFORMANCE ORDER

1. Lift the car.
2. Remove the sensor of ABS system (if it is provided).
3. Remove a back brake (see subsection 8.6).
4. Disconnect a cable of the emergency brake and a tube from the wheel cylinder.
	5. Turn off brake board nuts (are specified by shooters).
	6. Carefully get a half shaft assembled.
	7. Get laying from a bridge flange.
	8. Get an epiploon, having hooked a screw-driver.
9. Replacement of the bearing of a half shaft is carried out in car service.
10. Accurately press a new epiploon by means of a mandrel, having greased edges.
11. Establish new laying.
12. Carefully establish a half shaft.
13. Further assembly is carried out upside-down.