Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. 4-cylinder engines
      3.1.1. Specifications
      3.1.2. The types of repair which are carried out without removal of the engine from the car
      3.1.3. Installation of the piston of the 1st cylinder in compression step VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. The soaking-up collector
      3.1.6. Final collector
      3.1.7. Cam-shafts and pushers
      3.1.8. Head of cylinders
      3.1.9. Cover of the chain drive of cam-shafts
      3.1.10. Forward epiploon of the crankshaft
      3.1.11. Oil pallet
      3.1.12. Oil pump
      3.1.13. Flywheel (leading disk of the hydrotransformer)
      3.1.14. Back epiploon of the crankshaft
      3.1.15. Engine mount details
   + 3.2. V6 3,0 engines of l (1993-1994) and 3,4 l (since 1995)
   + 3.3. Dismantle and capital repairs of the engine
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

3.1.13. Flywheel (leading disk of the hydrotransformer)

Removal

PERFORMANCE ORDER

1. Disconnect the battery from weight. Lift the car and establish on supports. Remove transmission (check point).

2. Remove coupling.

3. Designate tags the provision of a flywheel concerning the crankshaft.

4. Turn off flywheel bolts (the leading disk of the hydrotransformer). Record a flywheel from a provorachivaniye, having rested a screw-driver against a gear wreath.

5. Carefully remove a flywheel (the leading disk of the hydrotransformer). On some cars with automatic transmission on both parties of the leading disk remote washers which store together with a disk are established.

Installation

PERFORMANCE ORDER

1. Clear a flywheel, check existence for surfaces of traces of deep development, furrows from rivets, traces of burning out and scratches. Insignificant damages can be eliminated with cleaning by a skin. Check deformation of the plane of a flywheel.

2. Clear and check a condition of the plane of the socket of a flywheel and the crankshaft. If it is revealed that the back epiploon of the crankshaft leaks before establishing a flywheel (the leading disk of the hydrotransformer) replace an epiploon.

3. Establish a flywheel (the leading disk of the hydrotransformer) on the crankshaft. Combine the tags put at removal. Before a wraparound of bolts grease carvings with the fixing structure.

4. Record a flywheel a screw-driver for a gear wreath and tighten fastening bolts with the set moment. Tighten opposite bolts. Execute a final inhaling for three-four stages.

5. Further assembly is carried out upside-down.