Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. 4-cylinder engines
      3.1.1. Specifications
      3.1.2. The types of repair which are carried out without removal of the engine from the car
      3.1.3. Installation of the piston of the 1st cylinder in compression step VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. The soaking-up collector
      3.1.6. Final collector
      3.1.7. Cam-shafts and pushers
      3.1.8. Head of cylinders
      3.1.9. Cover of the chain drive of cam-shafts
      3.1.10. Forward epiploon of the crankshaft
      3.1.11. Oil pallet
      3.1.12. Oil pump
      3.1.13. Flywheel (leading disk of the hydrotransformer)
      3.1.14. Back epiploon of the crankshaft
      3.1.15. Engine mount details
   + 3.2. V6 3,0 engines of l (1993-1994) and 3,4 l (since 1995)
   + 3.3. Dismantle and capital repairs of the engine
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

3.1.11. Oil pallet

Removal

PERFORMANCE ORDER

1. Disconnect the battery from weight.
2. Put the car on the emergency brake and block back wheels.
3. Lift a car front.
4. Remove mud guards of the engine.
5. Merge oil and remove an oil filter. Remove an oil indicator.
6. Remove the stabilizer of cross stability.
7. Remove exhaust pipes.
	8. Remove a cross-piece, having turned off bolts (are specified by shooters).
9. Remove a conditioner compressor arm
10. Remove the generator and an arm.
11. Remove the sensor of rotation of the crankshaft.
	12. Remove the left and right intensifying plates, having turned off bolts (are specified by shooters).
	13. Turn off bolts of fastening of a case of transmission (are specified by shooters).
14. Turn off pallet bolts.
	15. Incline and remove the oil pallet.
	16. Remove an oil receiver, having turned off bolts (are specified by shooters).

Installation

PERFORMANCE ORDER

1. Remove the consolidation remains from the demountable planes of the block of cylinders and the pallet. Wash out the condensed planes solvent.
2. Be convinced of purity of carving openings in the block of cylinders.
3. Check existence on the demountable plane of the pallet of deformations, especially about openings under bolts. If necessary align the plane a hammer.
4. Check a condition of an oil receiver, existence on it of cracks and a contamination of the filter of rough cleaning.
	5. At assembly establish new laying of an oil receiver.
6. Apply the sealant with a diameter about 3 mm roller on the condensed pallet plane, leading round openings from the inside.
Prevention The detail has to be established no later than 5 minutes after putting sealant.
7. Carefully install the pallet and wrap bolts. In three-four receptions tighten pallet bolts with the set moment, beginning an inhaling in the central part.
8. Further assembly are carried out upside-down. Fill in oil in the engine and replace the filter. Replace laying of an exhaust pipe of the muffler.
9. Start the engine and be convinced of lack of leaks.