Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. Suspension bracket and steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. Stabilizer of a forward suspension bracket
   9.4. Rotary fist
   9.5. Forward nave and bearing
   9.6. Spherical support
   9.7. Top lever
   9.8. Lower lever
   9.9. Back shock-absorbers
   9.10. Back stabilizer of cross stability
   9.11. Cross bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. Steering wheel
   9.15. Tip of steering drafts
   9.16. Cover of the steering mechanism
   9.17. Steering mechanism
   9.18. Pump of the hydraulic booster
   9.19. Power steering
   9.20. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes





9.7. Top lever
GENERAL INFORMATION

Top lever
1. Forelock
2. Plug
 3. Lever

Removal and installation
Prevention

Procedure belongs to back and all-wheel drive cars.

PERFORMANCE ORDER
1. Lift a car front.
2. Remove a support and take aside.
3. Disconnect wires from the speed sensor (if there is an ABS system).
4. Raise a jack the lower lever of a suspension bracket. Not to clean a jack.
5. Turn off a nut, remove a washer and an axis.
6. Check a condition of plugs.
7. If plugs are damaged (cracks, wear), replace (replacement of plugs is carried out in car service).
8. Assembly is carried out upside-down.
9. Tighten a nut with the set moment.
Prevention

To tighten a nut only after lowering of the car, on an equal surface. It is also possible to simulate load of the lever, having raised the lower lever a jack.
10. On rear-wheel cars check and adjust corners of installation of wheels.