| 1. Lift back part of the car. |
| 2. Establish supports under a bridge beam. |
| 3. Disconnect conducting of sensors of speed from bars. |
|
4. For removal of the top bar turn off nuts (are specified by shooters), remove washers and bolts of fastening to a frame and to the bridge. |
| 5. For removal of the lower bar turn off nuts, remove washers and bolts of fastening to arms on a frame and the bridge. |
| 6. Check a condition of plugs of bars. |
| 7. At detection of damages of the plug replace (replacement is carried out in car service). |
| 8. Installation of bars is carried out upside-down. |
| 9. Finally tighten nuts of fastening of bars after lowering of the car. |