Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. Suspension bracket and steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. Stabilizer of a forward suspension bracket
   9.4. Rotary fist
   9.5. Forward nave and bearing
   9.6. Spherical support
   9.7. Top lever
   9.8. Lower lever
   9.9. Back shock-absorbers
   9.10. Back stabilizer of cross stability
   9.11. Cross bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. Steering wheel
   9.15. Tip of steering drafts
   9.16. Cover of the steering mechanism
   9.17. Steering mechanism
   9.18. Pump of the hydraulic booster
   9.19. Power steering
   9.20. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes





9.14. Steering wheel

Removal and installation

PERFORMANCE ORDER
Prevention

The part of cars is equipped with a safety cushion which is in the container in the center of a steering wheel. To exclude casual operation of system the switch of ignition transfer to the situation Lock, disconnect from the battery from weight and wait not less than 2 min.
1. Expose a wheel in the provision of a driving on a straight line and disconnect the battery from weight.
2. Switch-off the container with a safety cushion (if it is provided) (see subsection 11.44).
3. Hook and remove the caps located sideways on a wheel.
4. Unscrew screws (with a krestovy head) fastenings of the container with a safety cushion. Turn out screws so that the flute of the screw came into a feedwell edge. At once stop a reversing of screws.
5. Raise the case.
6. Take away a latch and get the safety cushion socket.
7. Disconnect all sockets. which can prevent removal of a wheel (for example, the socket of a sound signal).
8. Turn off a nut and designate the provision of a wheel concerning a shaft.
9. Press a stripper a steering wheel. It is forbidden to remove a wheel in blows to a nave.
Prevention

After removal of a wheel it is forbidden to turn a shaft (or wheels) as centering of a spiral wire will be broken and the wire will break because of what the safety cushion at accident will not work. At casual violation restore centering before installation of a wheel.
10. Check centering of a spiral wire of a pillow.
11. Be for this purpose convinced that wheels are exposed in situation on a straight line and turn the coil case counterclockwise against the stop and turn off clockwise on 3 turns, having combined tags.
12. Installation of a wheel is carried out upside-down.
13. Combine tags and tighten a nut with the set moment.