Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. Suspension bracket and steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. Stabilizer of a forward suspension bracket
   9.4. Rotary fist
   9.5. Forward nave and bearing
   9.6. Spherical support
   9.7. Top lever
   9.8. Lower lever
   9.9. Back shock-absorbers
   9.10. Back stabilizer of cross stability
   9.11. Cross bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. Steering wheel
   9.15. Tip of steering drafts
   9.16. Cover of the steering mechanism
   9.17. Steering mechanism
   9.18. Pump of the hydraulic booster
   9.19. Power steering
   9.20. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

9.4. Rotary fist

Removal and installation

PERFORMANCE ORDER

1. Lift a front of the car and remove wheels.
	2. Remove the speed sensor (the arrow specified a bolt).
3. Remove a brake support.
4. Remove a brake disk.

5. Remove a brake board (at the left – brake board bolts on rear-wheel cars, on the right – brake board bolts on all-wheel drive cars).
6. Disconnect a tip of steering draft from a fist.
	7. Rasshplintuyte also release a koronchaty nut (not to turn off), then by means of a stripper to a vypressuyta a finger of a spherical support from the top lever.
	8. Rasshplintuyte also release a koronchaty nut (not to turn off) the lower support (it is specified by an arrow).
	9. By means of a stripper to a vypressuyta a finger of the lower support.
10. Disconnect a fist from levers of a suspension bracket and remove.
11. Assembly is carried out upside-down.