Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. Suspension bracket and steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. Stabilizer of a forward suspension bracket
   9.4. Rotary fist
   9.5. Forward nave and bearing
   9.6. Spherical support
   9.7. Top lever
   9.8. Lower lever
   9.9. Back shock-absorbers
   9.10. Back stabilizer of cross stability
   9.11. Cross bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. Steering wheel
   9.15. Tip of steering drafts
   9.16. Cover of the steering mechanism
   9.17. Steering mechanism
   9.18. Pump of the hydraulic booster
   9.19. Power steering
   9.20. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes





9.17. Steering mechanism

Removal and installation

PERFORMANCE ORDER
Prevention

On the cars equipped with a safety cushion rotation of a wheel after removal of the mechanism it is not allowed in order to avoid damage of a pillow. Record a wheel, having dressed on it a seat belt and having fixed a buckle.
1. Expose a wheel in the provision of a driving on a straight line, lift a car front.
2. Disconnect tips of drafts from fists.
3. Turn off 10 bolts and remove the lower guard of the engine.
4. Remove the stabilizer.
5. Designate the provision of an intermediate shaft and turn off a coupling bolt of the shlitsevy coupling of the cardan hinge (shooters specified bolts of the coupling of the hinge and union of tubes).
6. Disconnect from the steering mechanism of a tube of the hydraulic booster.
7. Turn off a nut and a bolt on the right side of the mechanism, a nut and a through bolt from other party (shooters specified nuts and bolts of fastening of the steering mechanism to a frame).
8. Remove the steering mechanism.
9. If the wheel shaft incidentally turned, remove a wheel and center the safety cushion wire coil.
10. Further assembly is carried out upside-down.
11. Tighten bolts and nuts with the set moment and remove air from the hydraulic booster.