| 1. Take off a gear belt and the leading asterisk of the crankshaft. |
|
|
2. Determine epiploon press fitting depth, then make an incision an epiploon edge (1 – the made an incision part) and carefully get an epiploon from the case of the oil pump, having hooked the screw-driver wound by a tape. |
| 3. Clear an opening under an epiploon and slightly grease an external surface and working edges of a new epiploon with oil for the engine. |
|
4. Carefully without distortions press a new epiploon into place by means of a mandrel with a diameter a little smaller than diameter of an epiploon. Depth of a press fitting is determined by the put tag. After installation be convinced that edges of an epiploon were not unbent. |
| 5. Establish other details upside-down. On engines of 3,4 l take measures not to damage an insert of the sensor of rotation of the crankshaft on the leading asterisk. |