Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
+ 3.1. 4-cylinder engines
- 3.2. V6 3,0 engines of l (1993-1994) and 3,4 l (since 1995)
3.2.1. Specifications
3.2.2. The types of repair which are carried out without removal of the engine from the car
3.2.3. Installation of the piston of the 1st cylinder in compression step VMT
3.2.4. Covers of heads of cylinders
3.2.5. The soaking-up collector
3.2.6. Final collectors
3.2.7. Belt of an asterisk of cam-shafts
3.2.8. Forward epiploon of the crankshaft
3.2.9. Epiploons of cam-shafts
3.2.10. Cam-shafts and pushers
3.2.11. Heads of cylinders
3.2.12. Oil pallet
3.2.13. Oil pump
3.2.14. Flywheel (leading disk of the hydrotransformer)
3.2.15. Back epiploon of the crankshaft
3.2.16. Engine mount details
+ 3.3. Dismantle and capital repairs of the engine
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes
|
Removal
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight. |
| 2. Remove a leveling chamber (see subsection 5.11.5). This procedure quite difficult therefore attentively study instructions in the present manual, designate all hoses and wires. |
| 3. Remove from wire candles. |
| 4. Designate and disconnect all hoses and wires from a cover and take aside. |
|
|
| 5. Turn off bolts of covers of heads of cylinders. In drawing 11 bolts of covers of heads of cylinders of the engine of 3,0 l, in drawing on the right – bolts of covers of heads of cylinders of the engine of 3,4 l are represented at the left. |
| 6. Uncover. If the cover does not give in, displace it in blows of a hammer through a soft pro-rate, or carefully open consolidation by the pallet. |
|
Installation
| PERFORMANCE ORDER |
| 1. Carefully clear the condensed surfaces of a cover and a head of cylinders, remove oil traces. |
|
2. Apply sealant on semicircular caps and establish them on a head of cylinders, apply sealant on flat sites of caps. Places of putting sealant on engines of 3,0 l are designated (1).
|
| |
3. Apply sealant on semicircular caps and establish them on a head of cylinders, apply sealant on flat sites of caps. Places of putting sealant on the engine of 3,4 l are designated by shading. |
| 4. Lay new laying on a cover, establish a cover, sealing washers and wrap nuts. On the engine of 3,4 l replace a sealant of casings of candles. |
| 5. Evenly tighten cover bolts with the set moment in 3-4 stages. |
| 6. Establish other details, start the engine and be convinced of lack of a leak. |
|
|
|