Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Pressure regulator
   8.11. Emergency brake
   8.12. Cables of the emergency brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Braking signal switch
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes





8.9. Hoses and tubes of a hydraulic actuator
GENERAL INFORMATION

The condition of hoses and tubes is recommended to check each 6 months.

Bracket of fastening of the union

 1. Tube

2. Bracket

3. Hose

Check and replacement
PERFORMANCE ORDER
1. Clear the union of dirt.
2. Turn out the tube union from a hose and get a bracket. Disconnect a hose from a support and remove.
3. Installation is carried out upside-down. At installation of a hose replace copper laying of the ring union. Arrange a hose so that it did not touch details of a suspension bracket and a steering (the car at assembly not to lift). Remove air from a hydraulic actuator.
4. When replacing tubes track that on all route they were fixed by collars.
5. Installation only of steel tubes, in accuracy corresponding to make of the car is allowed.