Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Pressure regulator
   8.11. Emergency brake
   8.12. Cables of the emergency brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Braking signal switch
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

8.12. Cables of the emergency brake

GENERAL INFORMATION

Cable arm on a bridge beam

The cable arm on a bridge beam – is specified by an arrow.

Cable arms on a frame

Cable arms on a frame – are specified by shooters.

Bracket of fastening of a cable

The bracket of fastening of a cable – is specified by an arrow.

Replacement

PERFORMANCE ORDER

1. Release the emergency brake. Lift the car and remove wheels.

2. Weaken a cable, having turned off a nut.

3. Disconnect a cable from a regulator crank.

5. The cable is established upside-down. Adjust the emergency brake.

4. Get a cable from arms, get brackets.

5. The cable is established upside-down. Adjust the emergency brake.