Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Pressure regulator
   8.11. Emergency brake
   8.12. Cables of the emergency brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Braking signal switch
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes





8.5. Brake disk
GENERAL INFORMATION
Prevention

Blocks change only in a set on one axis. When cleaning blocks to delete dust and dirt with wiping by the rags moistened in alcohol or special liquid it is forbidden to blow.

Check and removal

PERFORMANCE ORDER
1. Release nuts of wheels, lift the car and establish on supports. Remove wheels and wrap nuts of wheels into place to record a disk concerning a nave (to provide the application of effort to a disk it is possible to dress washers).
2. Remove a support and take aside.
3. Check a condition of a disk from both parties. At detection of traces of deep development (depth more than 0,38 mm) remove a disk and a proshlifuyta. At detection of traces from rivets of overlays for disk surfaces as it is specified in drawing – replace a disk.
4. Check a beating by means of the strelochny indicator. If the beating on the indicator exceeds norm, remove a disk and a proshlifuyta.
Prevention

The disk in general is recommended to be removed and ground periodically on it is dependent on indications of the indicator. At least it can be made by hand a small skin to reduce a roughness.
5. After polishing thickness of a disk should not be less maximum permissible which is cast on a disk.
6. After checks turn off wheel nuts and remove a disk.

Installation

Establish a disk and collect a brake upside-down. Lower the car.