Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car



Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Systems of heating, ventilation
   4.1. Specifications
   4.2. Antifreeze
   4.3. Thermostat
   4.4. Krylchatka of the fan and hydrocoupling
   4.5. Radiator and tank
   4.6. Oil cooler
   - 4.7. Pump
      4.7.1. Check
      4.7.2. Removal and installation
   4.8. Liquid temperature sensor
   4.9. Electric motor and chain of the fan of a heater
   4.10. Heater radiator
   4.11. Control panel conditioning block
   + 4.12. Central air
   4.13. Compressor
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes





4.7.2. Removal and installation

GENERAL INFORMATION

The pump of cooling liquid on 4-cylinder engines

1. Laying
2. Pump
3. Belt
4. Pulley
5. Coupling
6. Krylchatka
7. Casing 1
8. Casing 2

4-CYLINDER ENGINES

PERFORMANCE ORDER
1. Disconnect the battery from weight and merge cooling liquid (see subsection 2.33).
2. Take off all belts of hinged units.
3. Remove a casing of the fan and the fan.
4. Remove a pulley from the pump and disconnect hoses (see rice. The pump of cooling liquid on 4-cylinder engines).
5. Turn off bolts and remove the pump.
6. Carefully clear the demountable plane of a cover of the laying remains.
7. Installation is carried out upside-down. Tighten bolts with the set moment.

V6 ENGINE

Pump of the engine of 3,0 l

 
1. Inlet branch pipe
2. Thermostat
3. Laying
4. Pump

Pump of the engine of 3,4 l

 
1. Laying
2. Inlet branch pipe
3. Pump
4. Thermostat
5. Cooler N2 hose

Bolts of the pump of the engine of 3,0 l

Inhaling moment:

bolts And – 15,6 N. of m,
bolts In – 16,8 N. of m.

PERFORMANCE ORDER
1. Disconnect the battery from weight and merge cooling liquid.
2. Take off a gear belt.
3. Remove an arm of the generator and remove the thermostat from the pump.
4. Disconnect a cooler N2 hose from the pump.
5. Turn off bolts and remove the pump (see rice. Bolts of the pump of 3,0 l). Disconnect hoses.
6. Carefully clear the demountable plane of a cover of the consolidation remains.
7. Installation is carried out upside-down. Apply the sealant roller on the plane of the pump. Tighten bolts with the set moment. Keep in mind that bolts of the pump of the engine of 3,0 l have the different sizes (see rice. Bolts of the pump of 3,0 l).