Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
- 5. Fuel and exhaust systems
   5.1. Specifications
   5.2. Order of a decompression of fuel system
   - 5.3. Fuel pump and pressure of fuel
      5.3.1. Check of the pump
      5.3.2. Check of pressure of fuel
      5.3.3. Check of the regulator of pressure of fuel
      5.3.4. Main relay of system of injection of fuel (EFI) and relay of the fuel pump
   5.4. Hoses and connections
   5.5. Fuel tank
   5.6. Fuel pump
   5.7. Fuel level sensor
   5.8. Air filter
   5.9. Cable of a butterfly valve
   + 5.10. System of electronic injection of fuel (EFI system)
   + 5.11. Units of system of injection of fuel
   5.12. Service of an exhaust system
   + 5.13. System of decrease in toxicity of exhaust gases
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

5.3.2. Check of pressure of fuel

GENERAL INFORMATION

Places of connection of the manometer

A. On the engine of 2,7 l:
1. Fuel supply tube
2. Laying
3. A set for check of pressure

B. An arrangement of the regulator and distributor of fuel on l V6 3,4 engines:
the arrow specified a cap

PERFORMANCE ORDER

1. Performance of the procedure described below requires the manometer for measurement of pressure of fuel with a hose calculated on ^{pressure not less than 3 kgfs/cm2}. The tip of a hose has to have a design like "banjo", i.e. be condensed with a bolt with the internal through channel.

2. Check tension on the battery, turn off a stopper of a fuel tank and execute actions a decompression of fuel system.

3. Pressure of fuel can be checked in the specified places.

4. Transfer the selector of automatic transmission to the situation Park, or establish a manual transmission in neutral situation.

5. Transfer the ignition key to the situation ON and consider pressure. Compare to the standard.

6. If pressure is higher than norm, check purity of the return fuel pipe. If the contamination is absent, replace pressure regulator.

7. If pressure low, press the return hose. If pressure increases, replace pressure regulator. Otherwise check the highway of supply of gasoline, fuel the pump the filter.

8. Start the engine and determine fuel pressure idling. If pressure differs from norm, check a condition of a vacuum hose and the regulator of pressure (see subsection 5.3.3).

9. Stop the engine and be convinced that pressure of fuel remains at the level of 1,35 ^kgfs/cm2 within 5 minutes after a stop. If pressure falls down quicker, can be the cause leak in the fuel pump, the regulator of pressure or in a nozzle.