Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
- 11. Electric equipment
   11.1. Specifications
   11.2. Battery
   + 11.3. System of ignition
   11.4. Ignition coil(s)
   11.5. Ignition distributor
   11.6. Check and installation of the moment of ignition
   11.7. Block of electronic ignition
   11.8. Induction sensor
   + 11.9. System of a charge of the battery
   + 11.10. Generator
   11.11. System of start-up of the engine
   + 11.12. Starter electric motor
   11.13. Traction relay
   11.14. Check of tension
   11.15. Detection of short circuit
   11.16. Check of reliability of grounding
   11.17. Check of integrity of a chain
   11.18. Finding of not closed chain
   11.19. Search of malfunctions
   11.20. Safety locks
   11.21. Fusible crossing points
   11.22. Breakers
   11.23. Relay
   11.24. Breaker of indexes of turn / alarm system
   11.25. Switch of indexes of turn
   11.26. Lock of ignition and drum of the lock
   11.27. Switch of external lighting
   11.28. Screen wiper switch
   11.29. Lamps of headlights
   11.30. Adjustment of headlights
   11.31. Headlight case
   11.32. Replacement of lamps
   11.33. Receiver and loudspeakers
   11.34. Antenna
   - 11.35. Screen wiper electric motor
      11.35.1. Forward screen wiper
      11.35.2. Back screen wiper
   11.36. Switch of heating of back glass
   11.37. Heater of back glass
   11.38. Guard of devices
   11.39. Sound signal
   11.40. Electric drive of mirrors
   11.41. Cruise control
   + 11.42. Window regulator electric drive
   11.43. Electric drive of door locks
   11.44. Safety cushions
+ 12. Electroschemes





11.35.1. Forward screen wiper
GENERAL INFORMATION

The scheme for check of rotation of the electric motor of a screen wiper with a small speed

The scheme of check of shutdown of the electric motor in the provision of a self-locking device


Check
PERFORMANCE ORDER
1. Connect a crossing point (+) - a battery conclusion to a conclusion 2, and (-) - a conclusion – to the electric motor case (see rice. The scheme for check of rotation of the electric motor of a screen wiper with a small speed). The electric motor has to rotate with a small speed.
2. Connect (+) - a battery conclusion to a conclusion 1, and (-) - a conclusion – to the electric motor case. The electric motor has to rotate with a high speed.
3. Start the electric motor with a small speed, and disconnect a crossing point from a conclusion 2 in any situation except a self-locking device. Connect conclusions 2 and 3 and power a conclusion 4 (concerning the case). The electric motor has to be switched-off in a self-locking device position (see rice. The scheme of check of shutdown of the electric motor in the provision of a self-locking device).
4. If results these checks negative, the electric motor replace.

Drafts of a screen wiper

 
1. Electric motor
 2. Draft

Replacement of the electric motor of a forward screen wiper

PERFORMANCE ORDER
1. Remove a lattice of an air inlet and disconnect the electric motor socket.
2. Turn off bolts of fastening of a screen wiper (bolts are specified by shooters).
3. Get the electric motor and bring the lever out of gearing with draft.
4. Turn off bolts of fastening and remove draft.
5. Installation is carried out upside-down.